Reporting & assurance → Compliance runs the rule checks of the packs active on one asset for one year.
Run the checks
- Choose the Asset and Year.
- Read the Overall result, then one card per pack with its activation window and the counts “passed · failed · not applicable”.
- Each rule row shows Status, Rule (code and severity), Result and Evidence.
Some packs show a dated notice (Notice, Under review or Superseded) with a link to the Official source.
Pack status
BASE (GHG Protocol, ISO 14064-1, IPIECA) holds the structural checks. The regulatory and disclosure packs, for example OGMP 2.0, EU ETS, the EU Methane Regulation, UK ETS or US EPA GHGRP, were drafted from the official published texts with a citation for every rule and approved for publication by a subject-matter expert on 19 September 2026. A published pack version never changes; corrections and regulatory updates arrive as a new version.
A pack marked Draft has not been approved by the subject-matter expert yet; its rules may still change, and a corrected draft replaces the old one. Every pack in the library, including the four sustainability reporting packs below, is Published. The disclosure export templates are separate and still marked draft: they lay out the figures, they do not change a check.
Pack results are indicative checks on your data, not a regulatory opinion or legal advice. You remain responsible for your official submissions.
Sustainability reporting packs
Four packs check the data behind a sustainability report and come with a disclosure table in Reports (see Reports and exports):
| Pack | Framework | What it checks |
|---|---|---|
| GRI version 1 | GRI 305 Emissions 2016 with the GRI 11 Oil and Gas sector recommendations | Scope 1, Scope 2 by both methods, biogenic CO2, base year, consolidation approach, methane |
| GRI version 2 | GRI 102 Climate Change 2025 with GRI 11 | the same, plus the latest IPCC GWPs and two previous years for comparison |
| ISO14064_1 | ISO 14064-1:2018 GHG report content | direct and imported-energy emissions, biogenic CO2, base year, uncertainty, organisational boundary |
| SASB_EM_EP | SASB Oil & Gas – Exploration & Production (EM-EP-110a) | Scope 1, methane share, Scope 1 by source, share under emissions-limiting regulation |
| IPIECA | IPIECA / API / IOGP Sustainability reporting guidance 2020 (CCE-4, CCE-5, CCE-7) | Scope 1 by gas, Scope 2, consolidation approach, breakdown by source, flared gas |
Which GRI version? GRI 102 applies to reports published from 1 January 2027. Activate GRI version 1 up to reporting year 2025 and version 2 from reporting year 2026 (a 2026 report is published in 2027), using the activation dates on the asset’s Packs tab.
Biogenic CO2 from biomass and biofuels is reported separately from Scope 1 when a source has a biogenic share (see Asset setup). Results calculated before biogenic CO2 was tracked make the biogenic rules show Not applicable until the year is recalculated. CO2 captured and transferred out of a source is shown as transferred and net Scope 1 in the disclosure tables; totals stay gross.
Activate packs
Packs are activated per asset on the asset’s Packs tab (Setup → Hierarchy → the asset → Packs). Country presets only suggest them. If the page says “No pack is active on this asset in this year.”, choose a year inside the activation window or use Activate packs. Pack options that change which checks apply are on Settings → General (Regulatory pack options).
See Asset setup.